SonicAudioProcessor

const val SAMPLE_RATE_NO_CHANGE = -1: Int

Indicates that the output sample rate should be the same as the input.

SonicAudioProcessor()

Creates a new Sonic audio processor.

fun configure(inputAudioFormat: AudioProcessor.AudioFormat!): AudioProcessor.AudioFormat!

Configures the processor to process input audio with the specified format. After calling this method, call isActive to determine whether the audio processor is active. Returns the configured output audio format if this instance is active.

After calling this method, it is necessary to flush the processor to apply the new configuration. Before applying the new configuration, it is safe to queue input and get output in the old input/output formats. Call queueEndOfStream when no more input will be supplied in the old input format.

fun flush(): Unit

Clears any buffered data and pending output. If the audio processor is active, also prepares the audio processor to receive a new stream of input in the last configured (pending) format.

fun getMediaDuration(playoutDuration: Long): Long

Returns the media duration corresponding to the specified playout duration, taking speed adjustment into account.

The scaling performed by this method will use the actual playback speed achieved by the audio processor, on average, since it was last flushed. This may differ very slightly from the target playback speed.

fun getOutput(): ByteBuffer!

Returns a buffer containing processed output data between its position and limit. The buffer will always be a direct byte buffer with native byte order. Calling this method invalidates any previously returned buffer. The buffer will be empty if no output is available.

fun isActive(): Boolean

Returns whether the processor is configured and will process input buffers.

fun isEnded(): Boolean

Returns whether this processor will return no more output from getOutput until flush has been called and more input has been queued.

fun queueEndOfStream(): Unit

Queues an end of stream signal. After this method has been called, queueInput may not be called until after the next call to flush. Calling getOutput will return any remaining output data. Multiple calls may be required to read all of the remaining output data. isEnded will return true once all remaining output data has been read.

fun queueInput(inputBuffer: ByteBuffer!): Unit

Queues audio data between the position and limit of the inputBuffer for processing. After calling this method, processed output may be available via getOutput. Calling queueInput(ByteBuffer) again invalidates any pending output.

fun reset(): Unit

Resets the processor to its unconfigured state, releasing any resources.

fun setOutputSampleRateHz(sampleRateHz: Int): Unit

Sets the sample rate for output audio, in Hertz. Pass SAMPLE_RATE_NO_CHANGE to output audio at the same sample rate as the input. After calling this method, call configure to configure the processor with the new sample rate.

fun setPitch(pitch: Float): Unit

Sets the target playback pitch. This method may only be called after draining data through the processor. The value returned by isActive may change, and the processor must be flushed before queueing more data.

fun setSpeed(speed: Float): Unit

Sets the target playback speed. This method may only be called after draining data through the processor. The value returned by isActive may change, and the processor must be flushed before queueing more data.